Tag: Test Systems
-
Why We Start With Your Goal, Not Your Spec

Most LabVIEW test systems start with a goal, not a tidy spec. Here is how we figure out what your system actually needs to do before we build it. Read more
-
What Is This Number For? The First Question on Any Test System

Before we pick a sensor, we ask what the number is for and how fast it needs to respond. A LabVIEW consultant in Cleveland on scoping a measurement. Read more
-
Why When You Measure Matters as Much as What You Measure

A clean reading at the wrong moment can still give you the wrong answer. Why data timing and alignment decide whether a test result means anything. Read more
-
Turning a Vague Test Request Into Real Pass/Fail Criteria

Before we write any code we pin down the pass/fail criteria. Here is how fuzzy test requirements cost you, and where measurement uncertainty fits in. Read more
-
Why a Producer Consumer Loop Keeps LabVIEW From Dropping Data

A slow chart or log should not cost you samples. Here is how a producer consumer loop in LabVIEW keeps your data acquisition from dropping data. Read more
-
Nigel Is a Fast Draftsman, Not an Engineer

NI Nigel writes LabVIEW code fast, but it cannot test it. An honest first take after using NI Nigel on a real HTTPS controller project. Read more
-
Five Signs Your Test Stand Is About to Cost You a Production Day

A test stand rarely fails on a schedule. It fails on a Tuesday, in the middle of a run, when you can least afford it. The good news is that most of them warn you first — and good test stand automation in Ohio starts with reading those warnings early. Here are five signs we’ve… Read more
